LUXAPOOL Epoxy Pool Coating is a long proven solvent based, high solids, two part epoxy, designed specially for use as a high performance swimming pool finish. Is suitable for most pool surfaces including new and aged render, marblesheen, fiberglass and existing epoxy finishes. It is suitable for both salt and chlorinated pools. Once cured, provides [...]
POOLS PREVIOUSLY PAINTED WITH CHLORINATED RUBBER SURFACE PREPARATION 1. Using a stiff brush or broom, scrub the entire surface with diluted LUXAPOOL Concentrated Wash (mixed at a ratio of 500mL Concentrated Wash to 20L of warm water). This removes greasy contaminants such as sun creams, oils, body fats, etc. Pay particular attention to step areas and [...]
LUXAPOOL Chlorinated Rubber coatings are formulated specifically for application to new or old concrete, or previously painted chlorinated rubber finishes. They offer a cost effective, single pack, hard satin finish, with outstanding resistance to swimming pool chemicals and salt water. AREAS OF USE: The primary use of LUXAPOOL Chlorinated Rubber is water immersible applications such [...]
LUXAPOOL Structural Epoxy Filler is a specially formulated non-sag gap filling epoxy compound, ideal for swimming pool repair. This easy-to-use, two part, equal volume mix sets rapidly to a tough and chemical resistant final cure. Luxapool SEF adheres strongly to most surfaces including concrete, sound cement render, fibreglass, marblesheen, pebblecrete, stone and cleaned steel surfaces. [...]
Description LUXAPOOL Poolside & Paving is an acrylic based, trafficable, rubberised, durable coating for exterior use especially in poolside areas. The resultant surface is naturally textured to provide a superior standard of non-slip, even under wet conditions. Textured effects may also be varied using special rollers in final application. In-film anti-mould ingredients provide long lasting [...]
PEBBLECRETE SURFACES SURFACE PREPARATION 1. Completely drain the pool so that all of the pebblecrete surface can be checked carefully for soundness. If there exists any evidence of loose pebbles or drummy areas, the surface should be regarded as suspect and must not be painted before being repaired. Loose or drummy areas of pebblecrete [...]
Luxapool Epoxy Pool coating exhibit outstanding chalking resistance in immersion applications. However, they are not designed to be applied above the waterline. Where the fibreglass structure extends above the waterline, then an alternative coating system must be used. Epoxy coatings exposed to direct sunlight can exhibit severe chalking in a matter of weeks. For trafficable [...]
SURFACE PREPARATION 1. Marblesheen & Quartzon surfaces are prone to extreme variations in surface quality due to raw material variations, application techniques, additives and surface deterioration. As such, the pool must be completely drained so that thorough inspection can be made of the total surface area. Using a ‘notched hammer’ or similar, test for any [...]
SURFACE PREPARATION 1. The render should consist of fresh cement and pure, clean sand only. Do not use any waterproofing agents or cement additives in the render (such as bonding agents) as this may affect the adhesive properties of the paint. Allow the render to cure for a minimum of 21 days prior to any [...]
OLD UNPAINTED CEMENT RENDERED POOLS SURFACE PREPARATION 1. Old pools must be completely drained before application so that thorough inspection can be made of the total surface area. Using a ‘notched hammer’ or similar, test for any evidence of unsound areas in the pool structure. Rectify any ground water intrusion before surface treatment. (Note: This may [...]